Heat exchanger for Parra 80S and Teuva (100 l) water heaters
Toimitus:
Nouto tehtaalta 0 €
Toimituskulut tilauksen painon mukaan alkaen 25 €
The heat exchanger is installed into the water cauldron. Installation is easy, you just remove the water cauldron’s lid, mount the heat exchanger with the riser collar in the water cauldron, then connect the heat exchanger. Set the water cauldron’s lid back into place and the installation is complete. The pipes of the heat exchanger circle around the outer edge of the pot, so the cauldron can still be used normally. The hot water in the cauldron heats the cold water circulating inside the heat exchanger.
A mixing valve is available for the heat exchanger. The valve allows water to be dispensed at a desired temperature 35–60°C. The mixing valve prevents the use of scalding hot water.
The heat exchanger’s water can be used, for example, in showers, hand washing sinks and dish washing sinks. The heat exchanger is also handy for providing warm water, for example, for a pressure washer without its own water heater.
The heat exchanger requires pressurized water, such as water mains water, well water or lake water from a pump. In comparison to a hot water heater, the heat exchanger is an inexpensive alternative.
The heat exchanger with a riser collar is ready for installation upon delivery.
A connection kit is available as an accessory.
- Diameter 530 mm
- Height 510 mm
- Weight 7,8 kg
- The material is high-quality copper pipe, into which have been soldered 1/2" exterior-threaded brass connectors for connection to the water supply network
Heat exchanger for Parra 80S and Teuva (100 l) water heaters
